Publicidad
Idiomas disponibles
Idiomas disponibles
AI EDITRECORDING
6
, I1,,1_
The AI edit function enables
CD recording
without worrying
about
tape length
and track length.
When a CD is inserted,
the unit
automatically
calculates
track lengths.
If necessary,
the order of
tracks is rearranged
so that no track is cut short.
(Al: Artificial
intelligence)
AI edit recording
will not start from a point halfway into the tape.
The tape must be recorded
from the beginning
of either side.
Use the remote control from steps 3 to 6.
1 Insert the tape into deck 2, and press the DOLBY
NR button to turn Dolby NR on or off,
Insert the tape with the side to be recorded on first facing out
from the unit.
2 Press the CD button
and load the disc(s),
3 Press the EDIT/CHECK
button
once.
"EDIT" lights up and "Ar' flashes on the display.
Each time it is pressed,
the display changes
as follows.
_,_ AI EDIT ----* PRGM EDIT
4 Press one of the DISC DIRECT PLAY buttons to
select a disc.
5 Press the numeric buttons to designate the tape
length,
10 to 99 minutes
can be specified.
Example:
When
using a 60-minute
tape, press the 6 and 0
buttons.
In a few 8¢oond8,
the miorooomputer
determines
the tracks
to be recorded
on each side of the tape.
• The <14<1and I_I_
buttons are also available
to designate
the tape length.
Remaining
Selected
Tape length
time of side A tracks for side A
Tape side A (front side)
First press the O/O REC/REC MUTE button and
then press the <11_ button within 2 seconds to
start recording,
The tape is rewound
to the beginning
of the front side, the
lead segment is played through for 10 seconds,
and recording
starts.
When recording
on the front (side A) ends, recording
on the back (side B) starts.
To stop recording
Press the • button. Recording and CD play stop simultaneously.
To clear the edit program
Press the • CLEAR button twice so that "EDIT" disappears on
the display.
To check the order of the programmed
track numbers
Before recording, press the EDIT/CHECK button to select side
A or B, and press the -,41<1 or I_1_ button repeatedly.
Program
Programmed
number
track numbers
Tape side
Track number
To add tracks
from
other
discs to the edit program
If there is any time remaining
on the tape after step 5, you can
add tracks from other discs in the CD compartment.
1
Press the EDIT/CHECK
button to select side A or B.
2
Press one of the DISC DIRECT
PLAY buttons to select a disc.
3
Press the numeric
buttons to select tracks.
[]
goes out and _
starts flashing
on the display.
A track which has a playing
time longer than the remaining
time cannot
be programmed.
4
Repeat
steps 2 and 3 to add more tracks.
Time
on cassette
tapes
and editing
time
The actual cassette
recording
time is usually a little longer than
the specified
recording
time printed
on the label.
This unit can
program
tracks to use the extra time.
When the total recording
time
is a little longer
than
the tape's
specified
recording
time
after editing,
the display shows the extra time (without
a minus
mark), instead of the time remaining
on the tape (with the minus
mark).
• Recording
is inhibited
if the erasure
prevention
tab on either
side of the tape is broken
off.
• The AI edit function
cannot
be used with discs containing
31
tracks or more.
1 5
ENGLISH
Publicidad
