Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING THETIMER
27
,2
The duration for the timer-activated
period can be set between
10 and 240 minutes
in 10-minute
steps.
• if this step is not completed
within 4 seconds,
repeat from
step 1.
Prepare the source.
TO listen
to a CD, load the disc to be played first on tray 1.
To listen
to a tape, insert the tape into deck 1 or 2.
To listen to the radio,
tune in to a station.
Press the POWER button to turn the unit off after
adjusting
the voHume and tone.
remains
on the display alter the power is turned off (timer
standby
mode).
The unit can be turned on at a specified
time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
(See page 6.)
1 Press the TIMER button on the remote control
once to display _), and press the II SET button
within 4 seconds.
_) is displayed, and the hour flashes.
®
Ifyou do notpress the| | SETbuttonwithin4 seconds,another
operation
may start.
2 Designate
the
hour
of the timer-on
time
by
pressing the I<4 DOWN or IH_I UP button, and
the II SET button. Repeat to designate the minute
of the timer-on time.
After you designate the timer-on time, TIMER and one of the
source name flashes alternately on the display for 4 seconds.
3 Within
4 seconds,
press
one
of the function
buttons
to select a source.
"TIMER" and the selected source name flash alternately for 4
seconds, At this time, the selected function button does not
light up.
• If thi_ step is not completed within 4 seconds, repeat from
step 1.
• If the TUNER button is pressed, the band cannot be selected
in this step.
4 Within
4 seconds,
select
the
duration
for the
timer-activated
period with the 14_ DOWN or IH_I
UP button.
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
To check
the specified
time and source
Press the TIMER
button
on the remote
control.
The timer-on
time and the selected
source name are displayed
for 4 seconds.
However,
the duration
for the timer-activated
period will not be
displayed.
TIMER RECORDING
Timer recording
is applicable
for TUNER
and VIDEOiAUX
(with
an external
timer) sources
only.
Press the TIMER button twice on the remote control so that
appears on the display, and press the I I SET button within
4 seconds.
Repeat the steps shown above from step 2 and
insert the tape to be recorded into deck 2 after step 5.
To cancel
timer
standby
mode
temporarily
Press the TIMER
button
on the remote
control
so that _) or
disappears
on the display.
To restore the timer standby
mode, press again to display _) or
Using
the unit while
the timer
is set
You can use the unit normally
after setting
the timer.
Before turning off the power, repeat step 5 to prepare the source,
and adjust the volume
and tone.
• Timer playback
and timer recording
will not begin
unless the
power is turned
off.
• Connected
equipment
cannot
be turned on and off by the built-
in timer of this unit.
Use an external
timer.
21
ENGLISH
Publicidad
