Gibertini CRYSTAL 1000 Manual De Instrucciones página 22

ENGLISH
Read the Instructions carefully before operating the Balance.
This is an high accuracy Instrument and must be handled with care.
1. WARNINGS
The power supply pack of the Crystal 1000 complies with Electrical Protection Class II.
Before connecting the power, check that the operating voltage, indicated on the Power
MAY ONLY BE USED WITH THE POWER SUPPLY PACK SUPPLIED.
MUST ONLY BE OPERATED IN DRY, CLEAN AND VIBRATION-FREE ENVIRONMENT.
MUST NOT BE OPERATED IN AREAS WHERE THERE ARE EXPLOSION RISKS.
NOTE:
In case of improper setting of the balance parameters during setup, the balance may power-up in an
incorrect configuration.
The user can restore the factory configuration to avoid the malfunction as follows:
Disconnect the supply of the balance
♦
Hold the On/Off key pressed
♦
Reconnect the supply
♦
Release the On/Off key when the display shows 'Set Factory'
♦
Now the factory default settings are restored.
Page 16 of 42
NOTE
supply pack, matches the line voltage.
CRYSTAL 1000:
INSTRUCTION MANUAL - 60.50.638 3
CRYSTAL 1000
nd
edition – December 2014