Gibertini CRYSTAL 1000 Manual De Instrucciones página 34

ENGLISH
11.3. SERIAL COMMANDS
The balance responds to the following commands only if a CRYSTAL or EURO protocol is selected:
COMMAND
B
C
I
F
T
Notes:
Every remote control command must end with <CR>.
Line-feed characters are ignored.
Page 28 of 42
SERIAL REMOTE CONTROLS TABLE
Send data on display
Start calibration
Start continuous transmission of data on display
Stop continuous transmission of data on display
Tare command
INSTRUCTION MANUAL - 60.50.638 3
FUNCTION
nd
edition – December 2014
CRYSTAL 1000