Gibertini CRYSTAL 1000 Manual De Instrucciones página 48

ESPAÑOL
11.3. SERIAL COMMANDS
The balance responds to the following commands only if a CRYSTAL or EURO protocol is selected:
COMMAND
B
C
I
F
T
Notes:
Every remote control command must end with <CR>.
Line-feed characters are ignored.
Pàgina 42 de 42
SERIAL REMOTE CONTROLS TABLE
Send data on display
Start calibration
Start continuous transmission of data on display
Stop continuous transmission of data on display
Tare command
MANUAL DE INSTRUCCIONES - 60.50.638 Ed. 3 – Diciembre 2014
FUNCTION
CRYSTAL 1000