Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
9.2.1. SERIAL
This menu controls the serial output control parameters.
9.2.1.1. BAUD
Defines the transmission baudrate of the serial output from 1200 to 9600 baud.
9.2.1.2. BYTE FOR
Defines the format of the byte transmitted and may be set as:
DATA FORMATS
7 E 1
7 0 1
7 N 2
7 E 2
7 O 2
8 N 1
8 E 1
8 O 1
8 N 2
9.2.1.3. PROTOC
Is the protocol of the serial data output and may be:
EUROPE
CRYSTAL
PRINTER
For a detailed description of the different protocols refer to the section relative to the data transmission.
9.2.1.4. TRANS OPT
Selects three different comunication mode:
continue
When this mode is selected, the balance transmits a data at every conversion.
May be used to drive peripherals than can't issue a print command to the balance.
request
The balance transmits a data one more time when a valid command is issued by serial port.
The balance transmits a data one more time when a valid command is issued by serial port if
data stable
and only if the weight on the pan is stable. If the non-stable condition persist then, after 15
seconds, whatever there will be a transmission.
This parameter could be stored by STORE function (see 9.2.5)
9.2.2. CALIBR
The calibration function can be selected with this menu.
9.2.2.1. CAL OFF
9.2.2.2. CAL ON
Page 24 of 42
DATA BIT PARITY CHECK
TYPE
7
EVEN
7
ODD
7
NO PARITY
7
EVEN
7
ODD
8
NO PARITY
8
EVEN
8
ODD
8
NO PARITY
Both external and internal calibration are disabled
Both external and internal (if installed) calibration are enabled
INSTRUCTION MANUAL - 60.50.638 3
BIT STOP
1
1
2
2
2
1
1
1
2
nd
edition – December 2014
CRYSTAL 1000
Publicidad
