Kids II Cradle & Sway InGenuity Serie Instrucciones De Montaje página 36

EN
Before calling Bright Starts
We are always happy to take your call; however, if you have a question about the
operation of your InGenuity
quickly and easily:
Issue
Swing does not
function (swinging,
music, LEDs)
Seat will not recline
Shoulder straps do
not fit over baby or
are too tight
Seat tilts slightly
toward frame
Seat does not swing
Swing control LEDs
flash continuously
Seat stopped swinging
during normal operation
Swing speed does
not appear to change
with speed setting
Swing speed is slow
even at highest setting
Swing timer LEDs are
OFF
Cannot hear
music/sounds
Troubleshooting
...
™
product, these simple solutions may answer your question
™
Probable Cause
Electrical cables may
not be properly
connected
Backrest tube is
installed upside down
Shoulder strap height
setting is too low
NOTE: this condition is normal and does not affect performance
or safety. The Cradle & Sway Swing comfortably supports infants
up to 25 lbs. As baby's weight increases, the seat will appear
more level when occupied.
Did not perform all
steps required to start
swinging motion
Batteries are installed
incorrectly
Low Battery Indicator is
red upon button press
Did not push the seat
Swing has auto-shutoff
at 90 minutes
Swing control needs time
to adjust to new setting
Batteries are weak
Batteries are weak
Timer has not been
activated
Low Battery Indicator is
red upon button press
Volume Switch is in
OFF position
Music/Sounds reached
auto-shutoff
– 34 –
Solution
Separate the left upright frame tubes
above the Power (battery) Unit. Check
for a loose electrical connection.
Remove and reinstall the backrest
tube using correct orientation
Route the shoulder straps through the
next higher pair of slots in the seat pad
(see Step 5 on page 25)
1 Slide Power Switch to ON position
2 Select swing speed setting
3 Gently push the seat to start
swinging motion
Remove and reinstall the batteries,
orienting them to match the (+) and (–)
markings in the compartment
Replace all batteries with new
alkaline size D batteries
Gently push the seat to start swinging
motion
Slide Power Switch to OFF and ON
position to restart
Allow the swing control time to adjust
(wait for LEDs to stop flashing)
Replace all batteries with new
alkaline size D batteries
Replace all batteries with new
alkaline size D batteries
Operate swing without timer; auto-
shutoff occurs after 90 minutes
Press Swing Timer Select Button to
select 30, 45, or 60 minute operation
Replace all batteries with new
alkaline size D batteries
Slide the Volume Switch to the Low or
High position
Press the Music Button or Nature
Sounds Button to restart