Publicidad
Idiomas disponibles
Idiomas disponibles
Normatec Go Charger
1. USB-C cord port
2. Wall plug
3. USB-C cord (2 included)
OPERATING INSTRUCTIONS
WARNING! BEFORE OPERATING THIS SYSTEM: Read all warnings at the
beginning of this manual. If you do not understand these operating instructions,
contact Hyperice at +1.949.565.4994.
CHARGING THE SYSTEM
• Step 1: Plug the USB cable into the control unit
• Step 2: Plug the USB cable into the charger
• Step 3: Plug the USB charger into the wall outlet
• While the control unit is charging the battery status indicators will cycle
from left to right. When all 5 battery status indicators are on ON, this
means that the system is fully charged.
The control unit will NOT power on and cannot be operated while the USB
cable is connected.
Device is intended to be charged with the power adaptor provided or by 5V USB.
Connect only approved devices to this equipment, devices connected to the
equipment must meet the requirements of the IEC standards(e.g. IEC60950 safety
standards for information technology equipment and IEC60601-1 safety standards
for medical electrical equipment), the voltage of connector to signal input/output port
must be restricted to SELV(safety extra low voltage separated from supply mains by
2MOP, less than 42.2V and 60Vd.c.).The ME system configuration must meet the
requirements of the IEC60601-1 medical electrical system standard. Any personnel
who connect devices to the equipment's signal input/output port are responsible for
providing evidence that the safety certification of the devices has been performed in
accordance to the IEC60601-1 clause 16. If you have any questions, please contact
Hyperice at +1.949.565.4994 or your local Customer Care Center or representative.
SET UP THE SYSTEM
• Step 1: Secure the wrap tightly around your calf. Affix the two sides of the
hook and loop material together for a snug but comfortable fit.
• Step 2: Press the power button on the Normatec Go control unit firmly for
one second to turn on the system. While the control unit is on, the battery
LEDs and display screen will light up.
2
1
3
Publicidad
