STERWINS UP20 Instrucciones De Montaje, Utilización Y Mantenimiento página 214

FR
Pay particular attention using the machine for the first time: focus and dedicate all your
attention to this first use. Make the first trial on a free space with no obstacle and no surrounding
element.
4.5 OPERATION
ES
Before use : illustration 3.2 to 3.4
Before using your engine, please push the brake on and put bar and chain oil into the tank until
PT
the maximum mark is reached.
Now, after recharging your battery, you can put the battery into tool's battery port.
IT
Note: When removing the battery, hold it firmly and depress the battery relase button.
Switching on/off : illustration 3.5
EL Release the chain by removing the brake first.
Press the lock-off button, then press the on/off switch and hold in this position The lock-off
button can now be released.
Note: For switching off the tool, release the on/off button and push the brake back for security.
PL
When you have started your engine, before use, make sure the chain is well oiled. Put a
cardboard on the ground and run your chainsaw near the cardboard for 30~45 secondes, and
make sur there are some oil on the cardboard.
RU
Use as a tree saw: illustration 4.1 to 4.15
1. When using it as a high-altitude tree saw, follow the steps shown in the figure to buckle the
KZ
safety belt on the safety buckle at the rear of the machine firstly.
2. During operation, the operator installs the safety protection rope, and 2~3 people are
required to operate at the same time. Be careful and not cut with saw lifting above the head.
3. Operate with both hands when cutting to avoid dangerous situations caused by body shaking.
UA
4. When someone is cutting, other person need to be in an area beyond 2 times the height of
the tree.
5. The best route to safe escape is outside the 45-degree left and right range in the direction of
RO
fallen trees.
6. Felling a tree. Firstly, cut about 1/3 lenght of the tree diameter horizontally. Then cut out a
triangular based on the first cut. The third cut is on the opposite side of the tree, leaving about
50mm in the middle of the cuts. Finally, hammer a wedge into the third cut. The tree would act
EN
as a hinge.
7. Cutting a wood placed horizontally. Cut half length from bottom firstly, then cut the left half
from the top.
8. When the wood is bent downwards, cut half length from the top firstly, then cut the left half
from the bottom.
9. When the wood is bent upwards, cut half length from bottom firstly, then cut the left half
from the top.
10. When the wood has bulge, cut half length beside the bulge firstly, then turn down the wood,
cut the left half from the bottom of the bulge.
214