Front Wheel; Rear Wheel - Fulcrum RACING ZERO DB Manual Del Usuario

®
3.8 - CHECKING THE TIGHTNESS OF THE TUBELESS SYSTEM (TUBELESS RIM + TUBELESS TYRE)
• Check that the tyre and rim are in good condition.
• Check that the inside of the tyre and rim are perfectly clean; clean them with a cloth if necessary.
• Inflate the tyre to the working pressure and immerse the wheel with its tyre in a basin of water to check for cuts or punctures. Replace the tyre if necessary.
• If the leakage occurs in the valve zone, check:
- that the valve is that which is indicated in the Spare Parts Catalogue, which can be found at the website www.fulcrumwheels.com
- that the valve is screwed onto the adapter properly.
- that the ring is securely tightened. If the leakage persists, replace both of them
If the leakage occurs between the bead and the edge of the rim, disassemble the tyre, make sure that there are no cuts or punctures and repeat assembly.
If after all these checks the tightness of the Tubeless system is still not satisfactory, contact your nearest Fulcrum dealer.
4 - FITTING THE WHEEL ON THE FRAME
These wheels are compatible with different axle locking systems.

4.1 - FRONT WHEEL

• If the FRONT wheel is predisposed for "Quick Release" mounting follow the "Quick Release" instructions which came with the wheel.
• If the FRONT wheel is predisposed for HH12 / HH15 through-axle mounting follow the mounting instructions provided by the bicycle or fork manufacturer.

4.2 - REAR WHEEL

• If the REAR wheel is predisposed for "Quick Release" mounting follow the "Quick Release" instructions which came with the wheel.
12