Front Wheel; Rear Wheel - Fulcrum RED PASSION Manual Del Usuario

3 - FITTING THE WHEEL ON THE FRAME
These wheels are compatible with different axle locking systems.

3.1 - FRONT WHEEL

• If the FRONT wheel is predisposed for "Quick Release" mounting follow the "Quick Release" instructions which came with the wheel.
• If the FRONT wheel is predisposed for HH15 through-axle mounting follow the mounting instructions provided by the bicycle or fork manufacturer.

3.2 - REAR WHEEL

• If the REAR wheel is predisposed for "Quick Release" mounting follow the "Quick Release" instructions which came with the wheel.
WARNING!
Ensure that the knurled surfaces (1 – Fig. 16 and Fig.
17) of the external left hand (A – Fig. 16) and right
hand (B – Fig. 17) adaptors protrude with respect to
the surfaces (2 – Fig. 16 and Fig. 17) of the internal
QR adaptors which therefore make up the friction
surfaces with the frame. The knurled surfaces of the
adaptors must be in contact with the surface of the
fork at the front and with the frame itself at the rear
in order to prevent the risk of the wheel coming off.
Failure to observe the above requirements could
cause accidents, physical injury or even death.
• If the REAR wheel is predisposed for HH12 through-axle mounting for 135 or 142 mm width follow the mounting instructions provided by the frame or bicycle manufacturer.
10
A
16
1
2
E
B
17
1
2
E