NOTICE_CTS_EURO4_V3-04A.mif Page 19 Lundi, 6. mars 2017 10:27 10
ENGINE OIL LEVEL
CITYSTAR 125/200 cc
Too much oil will noticeably restrict the
vehicle's performance.
B
A
1
• Place the vehicle on its central stand on flat ground.
• Start the engine, let it run for a few minutes and then
stop it.
• Wait a few minutes for the oil to stabilise.
• Remove the cap/oil gauge (1).
• Wipe the cap/gauge and reinsert it into the filling orifice
without screwing it up.
• Remove the filler cap/gauge and check the oil level
• The oil level shall not be between the minimum (A) and
maximum (B) level marks without exceeding the latter.
• Add oil if necessary.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Scooters
CHANGING THE ENGINE OIL
CITYSTAR 125 cc Official type-approval code:
H4AFAA
We advise you to go to a registered
dealer for draining.
Oil contains substances which are
harmful to the environment. Your dealer
is equipped to dispose of used oil
without endangering the environment
and
in
compliance
with
standards.
Engine oil
SAE 10W30 Synthetic API
125 cc
SL/SJ
Official type-approval
SAE 5W40 Synthetic API
code: H4AFAA
SL/SJ
Quantity
1 l at oïl change
When the ambient temperature is below -10 °C, use
an oil of viscosity: 5W40.
5 W 40
10 W 30
°C
-30 -20 -10
0
10
20
30
°F
-22
-4
14
32
60
68
86 104
The engine must be drained when it is warm to allow the
oil to run easier.
1
current
• Place the vehicle on its central stand on flat ground.
• Put on protective gloves.
• Remove the drainage cap and its seal (1) and allow the
oil to drip into a recipient.
40
• Remove the strainer cap (2) and clean the strainer (3).
• Put back the drainage cap and strainer cap, fitted with
a new seal.
• Pour the required quantity of oil corresponding to the
manufacturer's standards into the filler hole.
• Start the engine and let it run for a short while.
• Add oil if necessary.
• Check that the oil drain plug is sealed.
FR
GB
DE
IT
ES
3
NL
2
GR
SE
PT
FI
DK
19/25