Publicidad
CAUTION
Thermo Scientific
Viewing/Changing the Shaker Speed
You can view/change the shaker speed value with the bath running or not. From the home screen
press the soft key below
2
0
RPM
Changing the Set Point
When operating without a lid, limit the maximum set point to 60°C.
The set point is the desired reservoir fluid temperature. You can change the set point with the
bath running or not. From the home screen press either arrow key to display:
29.9°C
50.0°C
x
to not save the change. The display returns to the home screen. Note After a 30 second delay if
neither key is pressed the display returns to the home screen, any change is
Selecting a Preset Set Point
The set point is the desired reservoir fluid temperature. You can select the set point with the bath
running or not. Or, from the home screen press
T1
35.0°C
T2 37.0°C
T3 50.0°C
T4 55.0°C
to display:
Press, and hold, the arrow keys to bring up the
desired value. The values are 0 and 30 to 200.
Once the desired value is displayed press
or
home screen.
Press, and hold, the arrow keys to bring up the
desired set point value. The range is 5°C to 100°C.
Once the desired value is displayed, in this case
50.0°C, press the soft key below
the change or press the soft key below
Use the arrow keys to select the desired set point
30 RPM
value. Once the desired set point is highlighted
50 RPM
press the soft key below
70 RPM
change and return to the home screen.
90 RPM
After a 30 second delay if neither key is pressed
the display returns to the home screen, any change
not
is
saved.
Operation
to save the change and return to the
not
saved.
.
to save the
Precision
|
Chapter 4
to save
x
4-3
|
Publicidad
