Connecting The Waste Bottle - SciCan STATIM 2000 G4 Manual Del Operador

3 Setting up your STATIM

3.3 Connecting the Waste Bottle

The waste bottle 1 is used to collect the wastewater after it has been converted to steam and then
drained from the cassette. To connect the waste bottle to the STATIM, follow these steps (see Figure 4):
1. Insert the exhaust tube
on the back of the unit and pull gently to
confirm a tight fit.
2. Cut the tube to length and slide the waste
bottle fitting
4
3. Place the free end of the tube into the
hole in the lid of the waste bottle and
hand-tighten the fitting. Do not coil the
exhaust tube.
4. Unscrew the lid and copper condenser
coil assembly from the waste bottle.
5
The lid and coil should come out together.
5. Fill the waste bottle with water to the
MIN line and replace the lid and copper
condenser assembly. Empty the waste
bottle often to avoid unpleasant odors and
discoloration of the contents. (A low-level
disinfectant, prepared according to the
manufacturer's instructions, may be added
to the waste bottle to remedy this situation).
As a minimum, empty the waste bottle each
time you refill the reservoir.
6. Place the waste bottle near the unit. Store
the bottle below the unit. The tube can
be routed through a hole, (8 mm/0.3˝ in
diameter) in the countertop and secured
with the provided nylon clamps.
2 into the fitting
into place.
2
5
Figure 4
Page 12
3
1
3
2
5
1
4