Edirol UR-80 Manual Del Usuario página 22

Names of Things and What They Do
12.
System Setting/Mode Select buttons
Use these buttons to switch settings and modes on the UR-80 itself.
You cannot assign MIDI messages to the System Setting/Mode Select buttons.
Button name
MEMORY
HQ/GM2
V-LINK
[MIDI CLK]
(SHIFT + V-LINK)
REC SOURCE
[INPUT MONITOR LEVEL]
(SHIFT + TIME)
SHIFT
* Buttons enclosed in square brackets [ ] (e.g., [MIDI CLK]) indicate that you are to operate the button while
holding down the SHIFT button.
22
Operation
By holding down the MEMORY button and pressing a TRACK STATUS button you can
switch among the eight memory sets stored within the UR-80.
When you press this button, one of the TRACK STATUS button LEDs will light to indicate
the currently selected memory set.
When the HQ/GM2 button is on, the Track Control section will be in Synth Edit mode,
allowing you to control the parameters of the included software synthesizer. Press the
button once again to turn it off and return to the previous track control functions.
For details on Synth Edit mode refer to "Synth Edit mode (p. 68)".
When the V-LINK button is on, the Track Control section will be in V-LINK mode, allowing
you to control V-LINK compatible video devices. Press the button once again to turn it off
and return to the previous track control functions.
For details on V-LINK mode refer to "V-LINK mode (p. 71)".
This switches MIDI Timing Clock (F8) transmission on/off.
* When you press the SHIFT button, the LED will indicate the F8 on/off status—not the
V-LINK on/off status.
Switches the input signal that is being sent via USB to the computer as the recording source.
ANALOG (LED unlit):
DIGITAL (LED lit):
Selects whether the input signal from the input jacks (1/2) and digital input jack will be sent
to the headphone jack and master output jacks.
Use [SHIFT] + TIME dial to adjust the monitor level.
* Input monitoring can be switched on/off from ASIO 2.0 compliant software such as
Cubase.
* Adjusting the input monitor level will not change the recording level.
OFF (LED unlit):
STEREO (LED lit):
MONO (LED blinking):
Use this in conjunction with other buttons in the Master Control section.
Only the signal from the input jacks will be sent to the
computer.
Only the signal from the digital input jacks (coaxial or
optical) will be sent to the computer.
The input signal will not be output. Use this setting if you
are "thru-ing" the audio data within your computer, or if
you have connected a mixer and are using the mixer to
directly output the input signal for monitoring.
The input signal will be output in stereo. Use this setting if
you have connected a stereo device to input jacks 1/2, or if
you are using the digital input jack.
The input signal from the input jacks or digital input jack
will be mixed to monaural and output. Use this setting if
you have connected a monaural signal such as guitar or
mic to the input jacks.
* The audio signal sent via USB to your computer is stereo.