Synth Edit Mode; Track Faders; Assign Button (Assign) - Edirol UR-80 Manual Del Usuario

Synth Edit mode

When you turn on the HQ/GM2 button located in the Master Control area, the Track Control
section will operate in Synth Edit mode. Synth Edit mode lets you edit the parameters of the
included Hyper Canvas high-quality software synthesizer. Since the parameters are controlled by
transmitting GM2-compatible MIDI messages, you can also use this mode to control any MIDI
device that responds to GM2 MIDI messages.
When you want to return to controlling your sequencer software, press the HQ/GM2 button once
again to turn it off.
* So that the master fader will always be able to control the overall volume, it will transmit the message
assigned by the selected "Memory Set" (p. 349), regardless of the selected mode. Even in Synth Edit mode,
the MASTER fader will not control the master volume of the software synthesizer.
In Synth Edit mode, the port from which MIDI messages are transmitted will be EDIROL UR-80 1
by default. You can use UR-80 Editor to change the output port.
* For details, refer to "UR-80 Editor" (p. 73).

Track faders

These adjust the volume of each channel.
You can control channels 1–16 by operating the track group select button.

Assign button (ASSIGN)

This button selects the parameters that will be controlled by the track control knobs. Press the
assign button successively to cycle through the available choices: PAN → SEND 1 → SEND 2
→ HQ.
Assign button
PAN
SEND1
SEND2
HQ
68
Parameter
Pan
Reverb send
Chorus send
Channel parameter