Waeco AirCon Service Center Instrucciones De Uso página 68

First start-up
6.3 Entering company data
The company data is printed out with every service log.
1. In standby mode, use the cursor keys
"Other selections":
2. Press ENTER to confirm.
3. Use the cursor key
4. Press ENTER to confirm.
5. Enter the password "3282".
6. The company data is shown in the third line of the display (6).
You can enter five lines, each with up to 20 characters.
In the display, the number of the company data row entered appears
after the message "Enter company data." ("01" to "05").
The company data row is selected with the cursor keys
7. Enter the desired data using the keypad (7) and the cursor keys:
To switch between upper and lower case letters, press the Info
key
To delete individual characters, press the key C briefly.
To delete the entire display line, keep the key C pressed.
8. Press ENTER to confirm.
9. Press STOP. The set data is activated.
10. Press STOP again to go to standby mode.
68
Short selection
Free selection
Other selections
ENTER-OK
to select "Service".
.
or to select
or
AirConServiceCenter
.