cecotec MAMBO Serie Manual De Instrucciones página 81

5. Ceramic plate
6. Dispenser base
7. Detachable motor
8. Removable bottom cover
The dispenser is placed on top of either of the two jars. To do this, all the parts that make up
the dispenser must be assembled. Fig. 13
1. Mount the removable bottom cover on the bottom of the dispenser base, respecting
the food drop hole and making sure that it closes the safety tab correctly in a clockwise
direction. Once fixed, turn the locking piece to fix it to the other joint; note that the other
joint has 3 holes where the removable bottom cover should fit. Fig. 14
2. After mounting the removable bottom cover, it is time to mount the motor. To do this,
press the motor assembly into its hole, taking into account that the gear must engage on
both sides. If it is not possible to engage the motor assembly, turn the gear slightly until it
engages again. To remove the motor assembly, use the tabs to pull it out. Fig. 15
Warning
Always remember to mount the removable bottom cap on the base of the dispenser.
-
It is important to perform this step without having mounted anything else on the base of
-
the dispenser so as not to activate the sensors prematurely and cause an impact on the
normal use of the dispenser.
1. Mount the sealing ring on the base of the container set by pressing the sealing ring into
the holes of the container set. The sealing ring is pressed into place facing the holes in
the bottom of the container set. Fig. 16
Warning
It is very important to assemble this sealing ring correctly, otherwise the food and liquids
in the bowls will not be sealed and will leak into the base of the ingredient dispenser, which
could cause problems.
2. After mounting the sealing ring on the container set base, mount the ceramic plate on the
sealing ring. It is very important to insert the flange of the container set into the recess of
the ceramic plate. Once it is well inserted, generate a little pressure on the ceramic plate
and close the lock in the centre of the ceramic plate by turning clockwise. Fig. 17
Please note
The food outlet must be in the same place as the container set outlet.
3. Once the 3 pieces, container set, sealing ring and ceramic plate have been assembled,
this assembly has to be inserted into the base of the dispenser. To do this, match the tab
on the ceramic plate, which is aligned with the food outlet hole, with the guide on the
MAMBO COOKING VICTORY_UNIQUE_TOTAL GOURMET
ENGLISH
81