cecotec MAMBO Serie Manual De Instrucciones página 82

ENGLISH
inside of the dispenser base. The dispenser should always have the same placement for
the order of the containers. Container 0 should be aligned with the inlet hole of the jar
and, clockwise, followed by containers 6 (liquids), 5, 4, 3, 2 and 1. Fig. 18
Warning
If the container set does not fit properly, move slightly to both sides until it fits properly.
4. Finally, after placing all the ingredients in all the containers, except for container 0, which
is in direct contact with the jar, close the cover. To do so, place the cover according to the
markings on the cover and on the food dispenser. Once fitted, turn the cover clockwise
and note the small "click" on the cover. Fig. 19
Assembling the removable dispenser cover grille
The cover of the dispenser consists of two pieces in the shape of a spider's web, one of which
is fixed to the cover, the other is removable for easy cleaning. You must press on the tab on
the lower edge of the part to remove it using the clipping system.
Assembling the food processor
The food processor is mounted by means of a shaft that is placed on top of the accessory
-
bracket, the two tabs protruding from the bracket must fit into the grooves of the
processor shaft. Once this shaft is in place, you have to place the grating or laminating
disc, using the large holes it has to insert the fingers so as not to cut yourself; depending
on which side you place it, you will be able to perform one of the functions.
Once the shaft and the disc are in place, proceed to place the cover through which the
-
food will be introduced. This comes with a presser to help introduce the food inside
through the cover. Fig. 27
Warning
Be careful with the cutting disc as it is very sharp.
Compatibility
Mambo CooKing Unique Cooking robot
Assembling the butterfly whisk
This accessory is installed on the upper part of the blade assembly. Its main function is to
-
whip cream, egg whites, or similar ingredients. In addition, this accessory helps mix food
without being chopped by the blades and removes lumps.
Install the butterfly whisk on the set of blades for the Victory XL jar, ensuring that the
-
centre of the shaft fits with the hollow of the butterfly accessory, and press down.
To make sure the butterfly whisk is properly fixed, when placing it, it must emit a "click"
-
sound. Once assembled, gently pull and check you cannot easily remove it. FIG. 11
82