Motorola Solutions PMPN4633 Manual De Usuario página 17

5.1.1
IMPRES 2 Battery
Table 6: Charging IMPRES 2 Batteries
Status
Charger Powers On
Battery Detected
Rapid Charging
Charged to 90 % or more
Charged to 95 % or more
Fault
Standby (Battery is waiting to
rapid charge)
NOTE:
● The "Hot Charger" message was introduced in V1.05 software.
● State of Charger percentage indications, with respect to Potential Capacity versus Rated Capacity,
was introduced in V1.11.01 software.
5.1.2
Unknown Battery
Some unknown batteries may not be detectable by the charger. Unknown batteries do not declare charging
parameters in a manner recognizable by the charger. If an unknown battery is detected, then the charger
indicates charging as summarized in the following table.
Pocket Display
IMPRES 2 CHARGER
IMPRES 2 BATTERY
RAPID CHARGE XXXX0mAh
yyy%
TRICKLE CHARGE xxxx0mAh
yyy%
CHARGE COMPLETE xxxx0mAh
yyy%
WARNING: NOT
CHARGEABLE REMOVE&
REINSERT
WARNING: HOT BAT-
TERY WAITING TO
CHRGE or COLD BAT-
TERY WAITING TO
CHRGE or VERY LOW
BATTERY WAITING TO
CHRGE
MN009418A01-AC
Chapter 5: Charging Procedure
LED Indicator
Green for approximately one
second
Steady Red
Steady Red
Blinking Green
Steady Green
Blinking Red
Blinking Amber
17