Motorola Solutions PMPN4633 Manual De Usuario página 21

5.3
Lithium-Ion Battery Preparation for Shipment
You can prepare IMPRES 2 or other Motorola Solutions Lithium-Ion batteries for shipment by air cargo using
an IMPRES 2 Multi-Unit Charger. Other battery types are faulted.
If the IMPRES 2 Lithium-Ion battery is equipped with a Sleep mode, the charger puts the battery to sleep
upon completion of Ship Lithium charge.
Prepare only stand-alone Motorola Solutions Lithium-Ion batteries for shipment. Remove the battery from the
radio before placing it into the charger.
Do not store a stand-alone battery in the charger. When preparation for Lithium shipment is complete,
immediately remove the stand-alone battery from the charger. Selection of Lithium shipment supersedes
calibration or reconditioning.
5.3.1
IMPRES 2 Battery
Preparing a Lithium-ion Battery for Shipment-IMPRES 2 Battery, must Charge
Table 10: Preparing a Lithium-ion Battery for Shipment-IMPRES 2 Battery, must Charge
Status
Charger Powers On
Battery Detected
Rapid Charging
Ship Lithium Complete
Fault
● Battery may not be making
proper electrical contact with
the charger.
● Battery is not an IMPRES 2
battery.
● An unknown condition is pre‐
venting the battery from be‐
ing discharged.
● Charging was completed be‐
fore the Ship Lithium goal
could be reached.
Charger Display
IMPRES 2 CHARGER
IMPRES 2 BATTERY
SHIP LI CHARGE xxx% Rat-
ed Cap
LI READY TO SHIP xxx%
Rated Cap
WARNING: NOT
CHARGEABLE REMOVE&
REINSERT or WRONG
BATT TYPE CANNOT
SHIP LI or CANNOT
DISCHARGE FOR LI
SHIPMENT or SHIP
INCOMPLETE Low Ca-
pacity:yy% or RADIO
POCKET CANNOT SHIP
LI or CHARGING
POCKET CANNOT SHIP
LI
MN009418A01-AC
Chapter 5: Charging Procedure
LED Indicator
Green for approximately one
second
Steady Red
Steady Red
Steady Green
Blinking Red
21