Publicidad
Idiomas disponibles
Idiomas disponibles
MN009418A01-AC
Chapter 12: Programming a Radio or Data Transfer through Communication Module
Chapter 12
Programming a Radio or Data Transfer
through Communication Module
Procedure:
1. Turn on the Multi-Unit Charger (MUC) and wait for 20 seconds for the MUC to completely power up.
2. Connect the radio to the USB type C cable.
3. Insert the radio into the MUC pocket.
4. Start the Integrated Terminal Management (iTM) programming session.
NOTE: In the event of power loss to the MUC, disconnect the USB cable from the radio and
remove the radio from the MUC pocket. Perform the procedure again by following steps 1
through 4.
48
Publicidad
