Publicidad
Idiomas disponibles
Idiomas disponibles
MN009418A01-AC
Chapter 5: Charging Procedure
Table 7: Charging Unknown Batteries
Status
Charger Powers On
Battery Detected
Rapid Charging
Nearly Charged (Battery Capaci‐
ty Unknown)
Charged (Battery Capacity Un‐
known)
Fault
Standby
●
Battery is waiting to rapid
charge.
●
Battery may be too hot, too
cold, or low voltage.
●
Charger is too hot.
5.2
Battery Preparation for Long-Term Storage
You can prepare Motorola Solutions IMPRES 2 Lithium-Ion, or Nickel batteries for Long-Term Storage in a
suitable location using an IMPRES 2 Multi-Unit Charger. Other battery types will be faulted.
If the IMPRES 2 battery is equipped with a Sleep mode, the charger puts the battery to sleep upon
completion of Long-Term Storage charge.
Prepare only stand-alone IMPRES 2 batteries for Long-Term Storage. Remove the battery from the radio or
device before placing it into the charger.
Do not store a stand- alone battery in the charger. When preparation for Long-Term Storage is complete,
immediately remove the stand- alone battery from the charger.
Selection of Long-Term Storage supersedes calibration or reconditioning. Lithium batteries prepared for
Long-Term Storage may not meet regulations for shipment by air cargo.
Motorola Solutions Lithium-ion or Nickel batteries may be prepared for Long-Term Storage.
18
Charger Display
IMPRES 2 CHARGER
UNKNOWN BATTERY
RAPID CHARGE
TRICKLE CHARGE
CHARGE COMPLETE
WARNING: NOT
CHARGEABLE REMOVE
& REINSERT
WARNING: HOT BAT-
TERY WAITING TO
CHRGE or COLD BAT-
TERY WAITING TO
CHRGE or VERY LOW
BATTERY WAITING TO
CHRGE or HOT CHARG-
ER WAITING TO
CHRGE
LED Indicator
Green for approximately one
second
Steady Red
Steady Red
Blinking Green
Steady Green
Blinking Red
Blinking Amber
Publicidad
