Publicidad
Idiomas disponibles
Idiomas disponibles
Pad saver
Mirka's pad savers are designed to protect the backing pad from wear and tear, when sanding aggressively and
continuously with net products . These cost-effective pad savers, placed between the backing pad and the sanding
strip, should be changed regularly . The pad savers prolong the life of the backing pad .
https://www .mirka .com/accessories/pad-savers/
Further service
Servicing must always be performed by trained personnel . To keep the tool warranty valid and ensure optimal tool
safety and function, servicing must be carried out by a Mirka authorized service center . To locate your local Mirka
authorized service center, contact Mirka Customer service or your Mirka dealer .
Troubleshooting guide
Symptom
The sander LED (right) is flashing
between red and green.
No light from sander LED (right) when
switched on.
The sander LED (right) is red and the
sander slows down to 5,000 rpm when
sanding.
The sander LED (right) is red and rpm is
slightly reduced.
The sander has stopped and LED (right)
is red.
Disposal information
DANGER
Disposal guidelines for old appliances . Render redundant power tools unusable by removing the
power cord . Only for EU countries . Do not dispose of electric tools along with household waste .
According to European Directives 2011/65/EU, 2015/863/EU and 2012/19/EU on waste electrical
and electronic equipment and their implementation under national law, electric tools that have
reached the end of their life must be collected separately and taken to an environmentally compatible
recycling facility .
Possible cause
Connected to a mains outlet with wrong
voltage .
Power cord not properly attached to the
sander or to the mains socket .
Temperature too high in the sander . Too
heavy long-term load .
Too heavy short-term load .
The tool is in safety mode due to high
temperature .
Solution
Connect the sander to a mains outlet that
matches the nominal voltage of the tool .
Connect it properly .
Reduce the load on the sander for some
time and the sander will speed up again .
Use lighter load and the LED (right) will
automatically change to green .
Wait until the tool has cooled down .
Mirka® DEOS 353X, 383X & Delta 663X • 110 V
en
15
Publicidad
