STERWINS 18VRLM1-400.1 Traduccion Del Manual De Instrucciones Originale página 48

Fault messages of the robot lawn mower in the LCD display (50)
Fault
Mower blocked
Too close to garage
Rolling over
Wheel slip
Anl_ST_400_SPK7.indb 48 Anl_ST_400_SPK7.indb 48
GB
Possible cause
- The obstruction sensor has
tripped several times within
one minute
- The obstruction sensor has
been constantly activated for
10 seconds
- The obstruction sensor has
tripped three times on the
way back to the charging sta-
tion (19)
- The robot lawn mower was
sent back too close to the
charging station (19).
- The robot lawn mower was
constantly tilted for 10 se-
conds.
- The robot lawn mower has
been tilted for a prolonged
time in one direction.
- The rear wheels (8) have
lifted due to an obstacle.
- The rear wheels (8) can ro-
tate freely due to an uneven
lawn.
- The wheels are dirty or the
ground is slippy.
- 48 -
Remedy
Press the STOP button (3) to open the dis-
play cover (23). Restart the mowing operati-
on via the control panel (2):
- Check whether the robot lawn mower
is blocked by an obstacle or jammed
between trees, bushes, etc. Remove the
obstacle or avoid this area.
- If this fault occurs frequently, check the
way in which the perimeter wire (18) has
been laid. Pay particular attention to tight
angles, corridors, fences, rocks, etc., and
adjust the layout of the perimeter wire (18)
if necessary.
- Check whether the grass is too tall and
the robot lawn mower gets blocked. If this
is the case, mow the grass with a conven-
tional law mower to below 60 mm.
- Check also that the grass on the side
of the boundary wire is not obstructing
the robot movement while driving along
the boundary wire, if necessary, trim the
edges of your lawn.
- If this fault occurs on the charging station,
ensure that the charging connector on the
charging station and on the robot are clea-
ned.
Press the STOP button (3) in order to open
the display cover (23). Re-start the mowing
operation on the control panel (2):
- The robot lawn mower should be sent
back to the charging station (19) at a mini-
mum distance of 2 m.
Press the STOP button (3) to open the dis-
play cover (23). Restart the mowing operati-
on via the control panel (2):
- Move the robot lawn mower to a level area
and restart it.
- If the robot lawn mower has tilted because
of a steep slope in the mowing area, ad-
just the perimeter wire (18) accordingly to
avoid severe inclines.
Press the STOP button (3) to open the dis-
play cover (23). Restart the mowing operati-
on via the control panel (2):
- Move the robot lawn mower to a level area
and restart.
- Make sure the whee are cleaned, clean
them with a brush if necessary.
- Repair the ground by fi lling the hole.
16.11.2023 11:32:30 16.11.2023 11:32:30