STERWINS 18VRLM1-400.1 Traduccion Del Manual De Instrucciones Originale página 49

Fault messages of the robot lawn mower in the LCD display (50)
Fault
STOP button error
PCB overtemp.
Rain
Sensor fault
Motor fault /
motor overcurrent
Breakdown
Anl_ST_400_SPK7.indb 49 Anl_ST_400_SPK7.indb 49
GB
Possible cause
The display cover (23) is open
but the STOP button (3) was
not pressed.
The temperature of the rechar-
geable battery is too high/low
or the controller is overheated
- If the battery temperature
exceeds 65°C, the robot
lawn mower will return to the
charging station (19).
- If the battery temperature ex-
ceeds 45°C or drops below
0°C, charging will be stopped
and the robot lawn mower
will wait at the charging stati-
on (19).
- The rain sensor (5) has trip-
ped.
- The robot lawn mower was
stopped due to a sensor er-
ror
- The robot lawn mower has
come to a stop because of
overcurrent in the motor or
because of a motor fault
- The robot lawn mower was
stopped due to an operating
error
- 49 -
Remedy
Press the STOP button (3) to open the dis-
play cover (23). Restart the mowing operati-
on via the control panel (2):
- Check whether the display cover (23)
can be opened and closed freely with the
STOP button (3).
- Check whether the STOP button (3) func-
tions correctly.
- Set the work time in summer to the early
hours of morning and avoid running the
robot lawn mower during the hours of the
day when it is hot.
- After the rechargeable battery or control-
ler has cooled down to the permissible
temperature range, the robot lawn mower
will automatically return to the program-
med operating mode
- Wait until the robot lawn mower has dried
out.
- A detailed description of the sensor can
be found in section 5.2.
Switch off the main switch (7) (OFF) and
then switch it back on (ON) again to restart
the robot lawn mower.
Switch off the main switch (7) (OFF) and
then switch it back on again (ON) to restart
the robot lawn mower.
- Check the height of the grass in the
mowing area and, if necessary, mow the
grass to below 60 mm using a conventio-
nal lawn mower.
- Increase the cutting height. Always start
with a higher cutting height and reduce it
in small steps until you reach the desired
height.
- Inspect the blade plates (11) and wheels
for dirt and give these parts a thorough
clean.
- Check the rear wheels and the blade plate
(11) for blockages. If you are unable to
remove the blockages, contact the res-
ponsible customer service center.
Switch off the main switch (7) (OFF) and
then switch it back on again (ON) to restart
the robot lawn mower.
16.11.2023 11:32:30 16.11.2023 11:32:30