Publicidad
Idiomas disponibles
Idiomas disponibles
11. Indicators on the charging station and troubleshooting
LED indicator (21)
Off
Lit up green
Flashing green
Lit up red
Anl_ST_400_SPK7.indb 46
Anl_ST_400_SPK7.indb 46
GB
Description
- No power supply
- Ready for mowing
- Rechargeable battery is ful-
ly charged
- Perimeter wire (18) connec-
ted
- Perimeter wire (18) is se-
vered
- Rechargeable battery is
charging
- 46 -
Solution
- Check the power supply
- If the boundary wire connection to the
charging station is correct, refer to the
troubleshooting of the robotic lawn mower
if there is any other problem.
- Inspect the perimeter wire (18) for a break.
1. Check the connection at the back of the
charging station, make sure both wire ends
are properly naked and fully inserted inside
each plugs.
2. Check for damaged boundary wire around
the lawn (the wire doesn't need to be com-
pletely cut to stop the signal)
3. If step 1 and 2 are ok, disconnect the two
ends of the boundary wire from the char-
ging station. Connect a 5m length wire to
the charging station and lay it down tem-
porarily on the ground.
a) Confi rm if the light is constant green, if
yes (constant green) => it means that the
signal is restored when using another wire.
Perform deeper inspection to detect where
the boundary wire is damaged or broken.
If using some connectors, make sure, the
wires are properly naked and fully inserted
and that the connectors is properly clam-
ped.
b) If light is still blinking => check the con-
nection at the back of the charging station,
make sure both wire ends are properly
naked and fully inserted inside each plugs.
If problem remains, contact your Aftersales
service.
- Wait until the rechargeable battery is fully
charged.
16.11.2023 11:32:29
16.11.2023 11:32:29
Publicidad
