Palmer supreme soaker Manual De Instrucciones página 10

USER MANUAL
CONNECTIONS, OPERATING AND DISPLAY ELEMENTS
The connections and the controls and display elements are colour-coded for easier orientation:
Orange: Signal path of the amplified signal from the amp to the speaker
Yellow: Signal path that leads to the LINE OUT and RE-AMP OUT
Grey: Signal path that leads to the headphone output (PHONES)
1
1. POWER INPUT
Low-voltage socket for supplying power to the device. To prevent damage to the device, please use only the original
power supply (included) or one of the Palmer power supplies PWT06IEC and PWT12IEC.
2. SPK/AMP
AMP IN
Amplifier input with a 6.3 mm jack socket. Use a high-quality speaker cable (min. 2 x 1.5 mm²) to connect the
speaker output of a guitar amplifier to the amplifier input AMP IN.
Caution when using guitar amplifiers with an output power of over 100 watts:
Make sure that the ventilation openings of the housing are not covered and that the device receives sufficient air
circulation. Monitor the heat development of the device regularly and keep a close eye on the "Burning Bus" LED
(see section 13, Overheating warning!). If this LED lights up, stop playing and allow the device to cool down.
AMP LOAD
Adjust the impedance required for your amplifier using the AMP LOAD switch before switching on the amplifier
(8Ω/16Ω).
SPK OUT
6.3 mm jack socket for connecting a guitar speaker. As the Supreme Soaker has internal load resistors, a guitar
cabinet does not necessarily have to be connected to the SPK OUT speaker output. When using a guitar speaker,
the impedance of the speaker should correspond to the impedance required for the amplifier. Use a high-quality
speaker cable (min. 2 x 1.5 mm²) to connect the SPK OUT speaker output to the input of a guitar cabinet.
EN
6 5 4 3 2
10