Palmer supreme soaker Manual De Instrucciones página 11

USER MANUAL
3. MIC/LINE IN
Combo socket XLR / jack
Audio input for a microphone (also suitable for a line playback source).
XLR input: Connect a suitable microphone using a microphone cable and pick up a guitar speaker. Set the volume
ratio between the amp and microphone signals on the front panel (LINE OUT, BLEND, AMP <-> MIC).
TRS jack input (-20 dB): Connect the line output of the amplifier using a line cable. Set the volume ratio between the
amp and line signals on the front panel (LINE OUT, BLEND, AMP <-> MIC).
PAD (Passive Attenuation Device)
The PAD circuit can be used to adjust the level range of the input stage to the level of the input signal. Distortion of
the audio signal can thus be effectively avoided.
0dB: No attenuation of the audio signal.
20dB: Attenuation of the audio signal by 20 dB.
Select the 0dB position if the gain of the input signal can be adjusted using the GAIN control on the front of the
device so that no distortion occurs in the signal and a sufficient signal level is achieved.
Select the 20dB setting if the lowest setting of the GAIN control on the front panel is not sufficient to avoid distortion in
the signal (SGN/PK indicator LED lights up red continuously or flashes red at peak levels, PK = Peak).
OFF/48V
48 V phantom power for use with a condenser microphone. Only switch on the phantom power after connecting the
microphone (switch in position 48V) and switch it off again before disconnecting the microphone (switch in position
OFF).
POLARITY
When mixing the amplifier and microphone signals, inverting the polarity of the microphone signal can prevent
unwanted cancellations (switch in position = standard polarity, switch in position = inverted polarity).
4. FX LOOP
Serial loop-in path (unbalanced) for integrating an external effects unit (reverb, delay, etc.). Set the volume ratio
between the direct and effect signals (dry / wet) on the effect device. NOTE: If only the send socket is used and the
return sockets remain unused, the signal path is interrupted.
FX SEND
6.3 mm jack socket for sending the signal to the external effects unit (FX SEND -> effects unit INPUT). Use a high-
quality line cable with TS jack plugs.
RETURN L/MONO - R
6.3 mm jack sockets for returning the effect signal (mono signal: effect unit OUTPUT -> RETURN L/MONO, stereo signal:
effect unit OUTPUT L + R -> RETURN L + R). Use high-quality line cables with TS jack plugs.
FX LEVEL PRO/INSTR
Switch for adjusting the send level.
Recommendation: PRO level = for rack effects in the studio, INSTR level = for effect pedals.
Select the appropriate setting for your effect device. Make sure that the input stage of the effect device is sufficiently
driven but not overdriven.
11
EN