Cameo PIXBAR G2 SMD Manual De Usuario página 13

Idiomas disponibles

ENTER – Press ENTER to access the menu level to make value or status changes, and to access

one of the sub-menus. Confirm value or status changes by pressing ENTER.

NOTES:

• Before navigating the unit menu, make sure that the control panel is dry and clean

so that its functionality is not impaired.

• Water on the control unit can lead to incorrect operation of the spotlight, e.g. in

outdoor operation. Therefore, after configuring the spotlight, activate the lock

function to prevent incorrect operation by water (Settings -> Display -> Autolock).

Deactivate the lock function: Press UP and DOWN simultaneously for approx. 5

seconds.

PRESSURE EQUALISATION ELEMENT

Pressure equalisation element to prevent condensation inside the housing. In order to ensure its

proper function, the element must be protected from dirt.

W-DMX

ANTENNA

™

Antenna for W-DMX

control.

™

CAUTION: To ensure IP65 splash resistance for the DMX and network sockets, the

special input and output sockets must be correctly sealed with the IP65 special plugs

or the rubber sealing caps must be used for sealing. When connected correctly, or

when sealed correctly with the rubber sealing caps, the POWER IN and POWER OUT

sockets are protected from water sprays in accordance with IP65.

OPERATION

NOTE

• As soon as the spotlight is correctly connected to the power supply, the following are displayed

in succession: "Update wait ..." (for service purposes only), "Welcome to Cameo", the model

name and the software version. After this process, the spotlight is ready for operation and the

previously activated operating mode is launched.

• If there is no input for approx. 30 seconds, the display automatically returns to the main dis-

play.

• Note on the main display in the operating modes with external control: As soon as the control

signal is interrupted, the characters in the display start flashing; if the control signal is present

again, the flashing stops.

• Briefly pressing UP when in the main display rotates the display by 180°.

Clpbsmdipg2