Cameo PIXBAR G2 SMD Manual De Usuario página 16

This will take you to the submenu for configuring the submenu items (see table).
Master Send to XLR
gain
Send to
W-DMX
DMX DELAY
Alone
STAND-ALONE DIRECT LED MODE
The stand-alone Direct LED operating mode allows you to set the dimmer, strobe, R, G, B and W
directly on the device, similar to a DMX control unit. In this way, an individual scene can be crea-
ted without an additional DMX controller.
Starting from the main display, press MENU to enter the main menu. Use UP and DOWN to select
Stand Alone, confirm with ENTER, then select Direct LED and confirm again with ENTER. Now
select the menu item you want to edit, confirm the selection, set the desired value and confirm
the entry.
STAND-ALONE OPERATING MODE PLAY SCENE / LOOP
(scene 1 - 8 / 8-step colour sequences 1 - 8)
Both the 8 available scenes and the 8 available loops are pre-programmed at the factory, but can
be customised in the Edit Scene or Edit Loop menu item.
Starting from the main display, press MENU to enter the main menu. Use the UP and DOWN
buttons to select the Stand Alone menu item, confirm with ENTER, then select the Play Scene/
Loop submenu item and confirm again. Now select Scene or Loop, confirm, select the desired
scene or loop and confirm the selection. Set the desired brightness under Dimmer and confirm
the entry.
16
Control signal is forwarded via DMX OUT
On Activate DMX control signal forwarding via W-DMX
Off Deactivate sending of the DMX control signal via W-DMX
Force to
Pairing with ready-to-pair W-DMX devices
pair
Unlink Disconnect all W-DMX connections
Set DMX delay for slave units: Off, 0.1 s - 2.0 s
Do not forward control signal