Cameo PIXBAR G2 SMD Manual De Usuario página 24

Use SPIN16 TV spigot for mounting
The mounting feet of the PIXBAR
without tools. To unfold a TV spigot, pull the spring-loaded locking bolt out of the locking hole in
the direction of the arrow (1), fold the TV spigot forwards and let the locking bolt engage in the
locking hole offset by 90° (2). Use suitable truss clamps for mounting. Ensure that the connections
are tight and that the headlamp cannot come loose. When mounting the headlamp overhead,
secure it with a suitable safety rope to one of the safety lugs provided (see marking).
1
Vertical hanging mounting on a truss
For vertical hanging mounting, up to three PIXBAR
following optionally available products must be used for this:
1 A suitable truss clamp with sufficient load-bearing capacity for the total load (e.g. half coupler).
2 One Omega bracket (article number CLOMEGABRACKET1).
3
One stop set (article number CLPBG2VERTIMOUNT).
4 One or two connecting elements are needed to connect two or three PIXBAR
re the connection (item number CLPBG2STACKKIT).
The safety eyelet of the top foot of the top bar serves as a safety point. Make sure that the safety
rope used to secure the bars is suitable for the total weight of the bars.
For optical reasons, the mounting feet can be folded to the side of the housing. A rubber buffer
prevents the surface from being damaged.
24
G2 have 16 mm TV spigots that can be extended and retracted
®
2
G2 may be connected to each other. The
®
G2 and to secu-
®