Assembly To The Wheelchair - Otto Bock The Back 476D10 RA15-17 Instrucciones De Uso

7 Assembly to the Wheelchair

A
2
1. Insert the rigid back bars (Fig. 6A, Item 1) into the receiving notches of the lower assembly
adapters (Fig. 6A, Item 2). Pull the closing latches of the assembly adapters securely over
the rigid back bars on each side of the back (Fig. 6B).
2. With the hook latches of the upper assembly adapters (Fig. 6B) lifted up, place the upper
assembly adapter hooks (Fig. 6B, Item 1) against the wheelchair back tubes.
3. Lock the hook latches of the upper assembly adapters in place (down position) as shown in
Figure 6C to prevent "The Back" from rotating forward.
„The Back"
B
1
Attention!
Back inclination setting must be carried out by qualified technical personnel. It is
important to ensure that the angle of the back is set to no more than 10 degrees in
the anterior plane and no more than 12 degrees in the posterior plane. Ensure that all
screws of the upper mounting elements are properly tightened after any adjustments
are completed, and ensure the stability of the wheelchair is checked.
Attention!
The lower assembly adapter notch can be positioned in either the posterior position
(Fig. 2) or in the anterior position; however, in the anterior position the seat depth
will be affected.
C
1
Assembly to the Wheelchair
6
Ottobock | 27