Saf-Fro DVU W500 Instrucciones De Funcionamiento Y Mantenimiento página 11

EN
Specific case of the step mode :
Go to the appropriate line for access to the parameters you want to set, and turn the right encoder to select the step you want to set:
line 1
Working mode (SYN, MAN FREE)
line 2
Last welding current measure
line 3
Réglage épaisseur
line 4
Wire speed
line 5
Hauteur d'arc / Arc length
line 6
Dynamism
line 7
Number of activated steps
Specific case of the « ADVANCED SEQUENCER »
The mode Advanced Sequencer enables the operator to sequence the welding into two distinct regimes. The display is then adapted to allow setting the
same parameter for the regime 1 at the left and the regime 2 at the right.
line 1
Working mode (SYN, MAN FREE)
line 2
Last welding current measure
line 3
On regime 1
line 4
On regime 1
line 5
On regime 1
Arc transfer and step mode activated
Post welding
Arc transfer of the regime
1 and 2
Post soudage
Wire speed
Arc length
Regime time
Trigger mode
Last welding voltage measure
Courant de soudage
Select the step to be set with the right
encoder
Select the step to be set with the right
encoder
Select the step to be set with the right
encoder
Trigger mode
Last welding voltage measure
On regime 2
On regime 2
On regime 2
10