Publicidad
Idiomas disponibles
Idiomas disponibles
EN
For slinging the wire feeder, you must use the metal hook at the base of the handle.
2.4. POSITIONNING THE WIRE
I1
Wire Feed unit
I2
Pin of the shaft of the reel locator
I3
Spool axle nut
I4
Flow meter option
Open the door of the wire-feed unit (I1) and ensure that it cannot fall.
Unscrew the spool axle nut. (I3).
Insert the spool of wire on the axis. Make sure that the locating pin of the shaft (I2) is properly located into the reel locator
Screw the spool nut (I3) back on to the shaft, turning it clockwise.
Lower the lever (I7) in order to free the idler rollers (I8):
Take the end of the wire of the spool and cut the distorted end piece.
Straighten the first 15 centimetres of wire.
Insert the wire via the inlet wire-guide of the plate.
Lower the idlers (I8) and raise the lever (I7) in order to immobilise the idlers.
Adjust the pressure of the idlers (I8) on the wire to the correct tension.
I5
Wire speed setting
I6
Gas purge button
I7
Lever locker of the idlers
I8
Idlers
6
Publicidad
