Publicidad
Idiomas disponibles
Idiomas disponibles
EN
3 - INSTRUCTIONS FOR USE
3.1. PRESENTATION AND SETTING UP
Wire feed interface :
Starting up of the installation :
At the start-up, the LCD display shows these following steps:
Adjustment in progress :
Contrast and backlight intensity setting :
The contrast and the backlight intensity are pre-set at the factory. However, it is possible to change them from the wire feeder when it is in adjustment.
To change the contrast, press and hold the OK button and turn the left encoder.
To change the backlight intensity, press and hold the button OK and turn the right encoder.
Welding parameter setting (§ 3.2 )
Zone A
Zone B
Preview and welding measurement (§ 3.3)
Program management (§3.4)
Zone C
Wire feeder configuration (§3.5)
Zone D
Displays the software version and the number of the wire feeder if several wire feeders are
used
Transit display « WELCOME BIENVENUE»
Work display depending on the state in which the installation was stopped.
When the power source is in a configuration where the setting is not allowed, the wire
feeder's interface is inactive and shows this message.
7
Publicidad
