Angelo Po 1G1BR1G Manual De Uso E Instalación página 38

The appliance has been tested before being put
into service.
The information provided below is intended to as-
sist in the identification and correction of any anom-
alies and malfunctions which might occur during
use.
Fault
Smell of gas.
The pilot light does not ignite.
The pilot light goes out.
The flame is yellow.
IT
IT
Burner control knob is stiff
GB GB
DE DE
FR FR
ES
ES
English
TROUBLESHOOTING
Occasional leak because flame has
The spark ignition devices are not
Air in pipelines due to long period out
The thermocouple has not warmed up
Burner dirty, heat exchange pipes
clogged, condensation drips.
FAULT
The user can solve some of these problems him-
self, but for others specific technical knowledge or
skill is required, and so they must only be carried
out by qualified staff with recognised experience ac-
quired in the specific sector of operation.
Causes
gone out.
working.
of use.
enough.
Gas valve malfunction.
- 12 -
Remedies
Turn off the gas supply tap
and ventilate the room.
Check that the ignition
devices are in good working order.
Light by hand with a naked light.
Important
Contact the after-sales service.
Make more attempts to light the
flame.
Make more attempts to light the
flame.
Important
Contact the after-sales service.
Important
Contact the after-sales service.
6