Publicidad
Idiomas disponibles
Idiomas disponibles
RECOMMENDATIONS FOR REPLACING PARTS
Before carrying out any replacement procedure, ac-
tivate all the safety devices provided and decide
whether staff at work and those in the vicinity
should be informed. In particular, turn off the gas
supply tap and prevent access to all devices which
might cause unexpected health and safety hazards
if turned on. If work parts have to be replaced, use
original spare parts only. The manufacturer de-
REPLACEMENT OF THE BURNER NOZZLE
To carry out this operation,
proceed as follows.
1 - Turn off the gas supply
tap.
2 - Pull off knob (A) and dis-
assemble handle (B).
3 - Remove the knob units
(F).
4 - Undo the screws (C) and
remove the panel (D).
5 - Unscrew the nozzle (E)
and replace it with the
one suitable for the type
of gas in use (see table at back of manual).
REPLACING THE BURNER AIR BUSHING
To carry out this operation,
proceed as follows.
1 - Turn off the gas supply
tap.
2 - Pull off knob (A) and dis-
assemble handle (B).
3 - Remove the knob units
(G).
4 - Undo the screws (C) and
remove the panel (D).
5 - Undo the screw (E).
6 - Extract the bushing (F)
and replace it with the
one suitable for the type of gas in use (see table
at back of manual).
7 - Tighten the screw (E).
REPLACING PARTS
A
B
F
A
B
G
- 19 -
clines all responsibly for injury or damage to com-
ponents due to the use of non original parts, or
extraordinary work on the appliance which may
modify the safety requirements without the manu-
facturer's authorisation. When ordering compo-
nents, follow the instructions provided in the parts
catalogue.
C D C
6 - Restore the initial conditions after completing
the operation.
C D C
8 - Restore the initial conditions after completing
the operation.
9
E
IDM-39605900900.tif
E
F
IDM-39605901000.tif
English
IT
GB
DE
FR
ES
Publicidad
