Publicidad
Idiomas disponibles
Idiomas disponibles
1.5
Machine logbook,
The contents of the logbook of this machine are not
provided; it is up to the owner to create or acquire
one in which the following is noted:
-
the name of the person in charge of
equipment
-
operator names and dates / periods of use
-
serial numbers of components
-
the number of hours of use,
-
the characteristics of the cables used
-
the number of hours the cables are used,
-
a record of incidents and actions taken to
remedy them
-
forecast dates of periodic inspections and
record of actual dates of inspections
1.6
Recommendations for use and general
safety
Before using this equipment, ensure:
- that you read and understand this entire
manual
- that no obstacles will obstruct the required
motion
- that
the
periodic
performed and recorded,
- that the electrical installation is designed and
protected according to current regulations
- that your material is stable and aligned, freely
with the load
- the load or machine movements will not trap
or crush you or other people; signal and block
access to the area under the load
- you can communicate with help in case of
need,
- that you have adequate lighting
Ensure:
- every day the correct operation of the
mechanisms, brakes, and emergency stop
- periodically
the
switches, structural elements and wire ropes
- regularly the presence of travel end stopper,
the presence of plates and safety instructions
(and their readability),
- safety of the suspension structure
- there is no accumulation of snow, ice, debris
or materials on the winch,
- that there are no obstructions on the façade or
in the shaft
- at the end of work, that the deactivation is
complete.
INSTRUCTION MANUAL
Electrical winches MOTRIX types 526&527
inspection
has
been
electrical
cables,
limit
- If a charge is to be raised by multiple devices,
the installation of these must be preceded by a
technical review by a competent technician
and then conducted according to this study,
including to ensure the constant distribution
of the load in suitable conditions.
During the operations of lifting, up and
down, the user must constantly observe the load and
the free end of the cable to prevent any risk of
collision. The load must be constantly guided
(EN14492-2); otherwise the use of rotation-resistant
wire rope would be necessary.
Check and apply local regulations concerning
the installation, use, maintenance and control of
lifting devices.
See also contraindications §2.6
1.7
Anchoring
The forces in the anchor points of the winch
and/or pulleys are different depending on the
installation; check your case with a qualified
technician: direct lifting / change of direction /
reeving.
If the anchoring is not provided by FIXATOR each
anchor must withstand, without any deformation, up
to 2.5 times the WLL of the winch, that is
- 1875kg for type 526J
- 2475 kg for type 527B 527N or 527E
- 3750kg for type 527D
and remain stable when subjected to this load.
(special case of reeving 1:1 or reeving 2:1, the
resistance must be of 5 times the WLL, that is
3750kg for type 526J, 4950kg for type 527B 527N
or 527E, 7500kg for type 527D; see §2).
Minimal withstanding of the hoist and/or pulley
anchorage:
Ref: 1813000210
Page: 5/21
Version: 42/22
Publicidad
