FIXATOR MOTRIX 526 Instrucciones De Uso página 38

The brake is worn
The adhesion system is worn or dirty
The Overload The load is too important or blocked
sensor turns The brake is incorrectly adjusted
on The power wire section is too weak
The steel wire is deteriorated
3.3 Spare parts
Use only FIXATOR original spare parts.
Note and send the information listed on the plate
shown below before requesting parts.
Main wear parts and estimated replacement
frequency (highly dependent on actual usage) :
Grooved pulley Ø8
Grooved pulley Ø9
Grooved pulley Ø10
Cable input guide Ø8
Cable input guideØ9Ø10
Crossing device Ø8
Crossing device Ø9Ø10
Cable outlet plate Ø8
Cable outlet plate Ø9Ø10
Pinion shaft 11 teeth
Pinion shaft 14 teeth
Pressure beam 750kg
Pressure beam 1000kg
Pressure beam 1500kg
Pressure system 1000kg
Pressure system 1500kg
Brake rotor
Capacitor 40F/400V
INSTRUCTION MANUAL
Electrical winches MOTRIX types 526&527
ref 215011 100h
ref 216072 100h
ref 216011 100h
ref 215012 400h
ref 216012 400h
ref 215013 400h
ref 216013 400h
ref 215014 400h
ref 216014 400h
ref 215015 /
ref 216015 /
ref 215017 /
ref 216016 500h
ref 216126 500h
ref 216017 /
ref 216127 /
ref 241920 400h
ref 241203 /
Adjust the brake
Verification
Check and correct before any restart
Capacitor 20F/400V
Capacitor 30F/400V
Capacitor 100F/400V
Travel end stopper
Pendant control
3.4 Disposal
Disassembly and disposal of the hoist must be in
accordance with the current regulations in force.
Electrical components, gear oils, greases, etc. ...
should be separated and sent to the appropriate
treatment locations.
3.5 Noise emission
The A weighted sound pressure levels
workstations is less than or equal to 70 dB (A)
Ref: 1813000210
Page: 17/21
Version: 42/22
ref 520220 /
ref 520219 /
ref 241202 /
ref 216073 /
ref 461020 /
at