English
Owner´s manual
5. CONTROL SYSTEM
1. Fuel Lever
The fuel lever is used for fuel flowing from the
fuel tank to carburetor. Set the fuel lever to the
"OPEN" position.
When not operating the engine, set the fuel
lever to the "CLOSE" position.
1. Cock
2. Engine Switch
The engine switch is used for opening or
closing ignition circuit. Set the engine switch
to the "OPEN" position to run the engine,
and set it to the "CLOSE" position to stop the
engine.
3. Choke Lever
The choke lever is used for opening and
closing the choke of the carburetor. Set the
choke lever to the "CLOSE" position for cold
starting. Set the choke lever to the "OPEN"
position for normal operation or the Engine's
warm starting.
1. Choke lever
4. Throttle Lever
Adjust the throttle lever to change the engine
speed, in this way the water discharge is
regulated. For a higher discharge of water, put
the throttle in "HIGH" , for a lower discharge,
put the throttle lever in the "LOW" position.
1. Throttle lever
5. Recoil Starter
Pull the recoil starter to start the engine.
Don't allow the starter grip to snap back
against the engine. Return it gently to
prevent damage to the starter.
1. Starter grip
26
CLOSE
OFF
ON
CLOSE
HIGH
1
1
OPEN
1
OPEN
1
LOW