VEVOR APD30 Manual De Instrucciones página 5

humid , wet or badly lit environments , close to inflammable liquids or gas.
1.24 Do not touch the switch and the cable with a wet hand.
1.25 Only utilize the machine with the correct voltage. Normal usage gives
better results.
SAVE THESE INSTRUCTIONS
2.Installation
2.1 Remove the protection film , avoid contact with utensils that can
damage the surfaces , check that machine is not damaged. Please contact
with the manufacturer if it is damaged.
2.2 The machine must be installed in dry ,adequate ventilation and lighting
environment condition. Position the machine on a flat and firm place ; you
can put it on a workbench whose height fits you(about 700-900 mm) , and
leave a space around it of 150 mm for easier usage and cleaning.
2.3 Connect the machine to the electric net by an electric technical
personnel. It is suggest that using copper wires (at least 2.5 mm2) for the
electric wires. It is important to have a good ground system and a
protection switch (5-10A).
2.4 It is necessary for safety to check the cable carefully and verify it is not
damaged before put the plug to the receptacle. The receptacle must be
easily accessible ,must not require any kind of movement. The cable from
the machine to the receptacle must not be pulled tightly , also do not rest
the machine on the cable.
3.Operation
3.1 The machine has the following control devices on the front panel:
A--Red button to stop the machine
B--Green button to start the machine
- 4 -