Permissible Forces And Torques On The Pump Flanges (Only Pbs Pumps) - salmson SIL Serie Instalacion Y Puesta En Servicio

6.3 Permissible forces and torques on
the pump flanges (only PBS pumps)
Fig. 39: Permissible forces and torques on
the pump flanges – pump made of grey
cast iron
DN
32 315
40 385
50 525
65 648
80 788
100 1050
125 1243
150 1575
50 578
65 735
80 875
100 1173
125 1383
150 1750
200 2345
Table 3: Permissible forces and torques on the pump flanges
Installation and operating instructions SIL, PBS (with cartridge mechanical seal)
Z
Y
X
Z
Y
X
Forces F [N]
F F F
X Y Z
298 368
350 438
473 578
595 735
718 875
945 1173
1120 1383
1418 1750
525 473
648 595
788 718
1050 945
1243 1120
1575 1418
2100 1890
See Fig. 39 and list "Table 3: Permissible forces and torques on the
pump flanges" on page 43.
Values in acc. with ISO/DIN 5199 – class II (2002) – Appendix B, Family
no. 1A.
Σ Forces F M
X
578 385
683 455
910 490
1155 525
1383 560
1838 613
2170 735
2748 875
910 490
1155 525
1383 560
1838 613
2170 735
2748 875
3658 1138
If not all working loads reach the maximum permitted values, one of
these loads may exceed the normal limit value under the condition
that following additional conditions are fulfilled:
• All force and torque components must be limited to 1.4 times of the
maximum permitted value.
• The following equation applies to the actual forces and torques acting
on every flange (the following condition must be fulfilled):
actual
max.permitted
Where the total load ∑ F and ∑ M is the arithmetic total of every
flange (inlet and outlet), for the actual as well as the maximum per-
mitted values, without taking into consideration their algebraic sign,
at the pump level (inlet flange + outlet flange).
Torques M [Nm]
M M Σ Torques M
Y Z
263 298
315 368
350 403
385 420
403 455
438 508
525 665
613 718
350 403
385 420
403 455
438 508
525 665
613 718
805 928
actual
max.permitted
English
560
665
718
770
823
910
1068
1278
718
770
823
910
1068
1278
1680
43