Forno FBOEL1371-30 Manual De Instrucciones página 18

Installation Instruction (continued)
A
B
C
1. Disconnect power
2. Connect the 2 black wires b together using a UL listed wire connector.
3. Connect the 2 red wires c together using a UL listed wire connector.
4. Untwist white wire from green (or bare) ground wire coming from the oven.
5. Connect the 2 neutral (white) wires h together using a UL listed wire connector.
6. Connect the ground (green or bare) wire f from the oven cable to the ground
(green or bare) wire (in the junction box) using a UL listed wire connector.
7. Install junction box cover
STEP 5: Mount the oven
1. Slide the oven completely into the cabinet until the back surface of the front frame touches the front wall of the cabi-
net. Center the oven within the cabinet cutout. NOTE: Push against seal area of the oven front frame when pushing
the oven into the cabinet. Do not push against the outside edges.
2. There are four holes, two on each side of the front frame that surrounds the oven cavity. Drill 1/8" (3.18 mm) pilot
holes through the holes, and into the front wall of the cabinet.
3. Insert the # 8–14 x 1" screws (provided) through the pilot holes to securely fasten the oven to the cabinet. Do not
over-tighten screws.
4. Replace the rack and reconnect the power to the oven.
18
Ungrounded Neutral
I
D
Junction Box
A
Black Wires
B
Red Wires
C
Cable from Oven
D
H
UL listed or CSA Approved
E
G
Conduit Connector
Ground (Green or Bare) Wire
F
F
UL Listed Wire Connectors
G
E
Neutral (White)Wires
H
House Electrical Supply
I
A
Mounting Frame
B
Mounting Frame Hole