Giropes Baxtran BS-TRI Manual De Usuario página 11

6.4 SET BACK LIGHT
In the weighing mode, press and hold
Display will be show "BK-AU".
Press key to change display to:
• BK- AU to set back light turn on automatically
• BK- OFF to set back light turn off always
• BK- ON to set back light turn on always
6.5. SET LIMITS
In the unverified version to set the limits you have to press
will show 02.00H (H for hi in English upper limit) the letter H will flash. Pressing
and pressing will go to the next value, when reaching the last value the upper limit is confirmed.
Then the viewer will show 01.00L (L, lower limit in English low) and we repeat the same operation as with
the upper limit.
Then the display will show END.
You have to activate the limits mode, pressing
with we go to F10 we press
show F10, we turn off and turn on the scale again.
6.6 SET CHECK WEIGHING
Beep mode see parameter F7 BEP
• Check mode 0 : No beep sound in the limits. Function turned off.
• Check mode 1 : When the weight is between the limits. And beeper will be sounded.
• Check mode 2 : When the weight is out of the limits, the beeper will be sounded.
7. PARAMETERS & CALIBRATE
7.1 ENTER SETTING MODE
The scale has 11 parameters that can be set by the user plus a method of entering the calibration section.
To set parameters or calibration, first turn off the weighing scales, then press
show "F0 CAL".
Press back menu in the parameter to return to the weighing mode.
Parameters with an asterisk * are blocked by the calibration button. To access them you have to break the seal,
thus losing the verification.
7.2 CALIBRATE*
After enter setting mode, the display will show "F0 CAL". Then press the calibration switch to enter calibra-
tion.
key.
in the countdown when turning on the machine,
and with we put the function ON, we press
USER'S MANUAL BS-TRI
and in weighing mode
changes the value,
key until display
EN EN
, it will
11