Thermador Professional Serie Guía De Uso Y Cuidado página 22

Part
Door glass
Painted surfaces
Stainless steel
surfaces
Plastic & Controls
Printed areas
(words & numbers)
Cleaning the ventilation filters
The ventilation filters should be removed and
cleaned often; generally at least once every month.
CAUTION
9
To avoid risk of personal injury or property
damage, do not operate the ventilation without
filters properly in place.
NOTICE: Use both hands to remove the filter to prevent
it from dropping down.
To remove the ventilation filters, release the catch by
1.
pulling it down with your finger. The filter will drop
down at the front. Then pull filter towards you to
remove it. The filter will drop out. Repeat for the 2nd
filter.
Soak the ventilation filters in hot water using a mild
2.
detergent. Rinse well and shake to dry. You can also
wash the filters in a dishwasher.
To reinstall the ventilation filter, slide the two pins at
3.
the rear side of the filter into the slots at the rear of the
filter opening, then push up filter at the front until the
catch locks in place with a click. Reinstall the 2nd filter
using the same procedure.
22
Recommendations
Wash with soap and water or glass cleaner. Use Fantastik
sponge or paper towel and wipe clean. Avoid using abrasive cleaners, like powder cleaning
agents, steel wool pads and oven cleaners.
If steam accumulates inside or outside the appliance door, wipe with a soft cloth. Steam
can accumulate when operating the appliance in high humidity and in no way indicates
microwave leakage.
Clean with hot soapy water or apply Fantastik
towel and wipe clean. Avoid using abrasive cleaners, like powder cleaning agents, steel wool
pads and oven cleaners.
Always wipe or rub in the direction of the grain. Clean with a soapy sponge, then rinse and
dry, or wipe with Fantastik
Magic and a soft cloth. Remove water spots with a cloth dampened with white vinegar.
®
Do not use any cleanser that contains chlorine as these may rust the stainless steel.
When cool, clean with soapy water, rinse and dry.
Do not use abrasive cleaners or petroleum based solvents.
or Formula 409
®
sprayed on a paper towel. Protect and polish with Stainless Steel
®
Maintenance
Charcoal filter replacement
The charcoal filter, which was included with your
appliance, is used for nonvented, recirculated
installation (Room Venting). The filter should be replaced
every 6 to 12 months depending on use.
Disconnect power to the appliance at the circuit
1.
breaker panel or by unplugging.
Remove the vent grill mounting screws.
2.
3. Pull the microwave vent grill away from the
appliance.
or Formula 409 on a clean
® ®
to a clean sponge or paper
®