Weber SUMMIT S-670 Guia Del Propietario página 29
Ocultar thumbs
Ver también para SUMMIT S-670:
- Guia del propietario (154 páginas) ,
- Instrucciones de montaje (4 páginas) ,
- Apéndice a la guía del propietario (2 páginas)
Publicidad
Idiomas disponibles
Idiomas disponibles
REMOVING THE SEAR STATION
TM
BURNER
To remove the Sear Station Burne¢ M,pull the burner tube toward you. This removes it
from the burner tube notch (a.). Then rotate the tube clockwise
(b.), taking care to rotate
the burner tube so that the screw at the end of the tube (d.) fits through the notch in the
heat shield opening (e.). When the burner tube is free, remove it from the firebox (c.).
10)
To reinstall the manifold assembly, reverse steps 7 through 9.
Z_ CAUTION:The
burner openings (A) must be positioned
properly over the valve orifices (B).
Make sure the opposite
end of the burner tubes (C) properly
align into the slots on the backside
of the cookbox. Check
proper assembly
before fastening
manifold in place.
Z_ WARNING: After reinstalling
the gas lines, they should
be
leak checked with a soap and water solution before using
the grill. (See, "Check for gas leaks.")
ANNUAL MAINTENANCE
INSPECTION
AND CLEANING OF THE SPIDER/INSECT
SCREENS
To inspect the Spider/Insect
screens, remove the control panel. If there is dust or dirt on
the screens, remove the burners for cleaning the screens.
Brush the Spider/Insect
screens lightly with a soft bristle brush (i.e. an old toothbrush).
z_ CAUTION: Do not clean the Spider/Insect
screens with hard
or sharp tools. Do not dislodge
the Spider/Insect
screens or
enlarge the screen openings.
Lightly tap the burner to get debris and dirt out of the burner tube. Once the Spider/
Insect screens and burners are clean replace the burners.
If the Spider/Insect
screen becomes
damaged or cannot be cleaned,
please contact the
Customer Service Representative
in your area using the contact information
on our web
site. Log onto www.weber.com
®.
BURNER FLAME PATTERN
The Weber ¢ gas barbecue burners have been factory set for the correct air and gas
mixture. The correct flame pattern is shown.
1)
Burner tube
2)
Tips occasionally
flicker yellow
3)
Light blue
4)
Dark blue
If the flames do not appear to be uniform throughout
the burner tube, follow the burner
cleaning procedures.
Publicidad
