GreenWorks Tools 51027 Manual De Utilización página 24

EN
FR DE ES
PROBLEM
Motor will not start.
Unit does not reach
high pressure.
Output pressure varies
high and low.
IT PT NL SV DA NO
ENGLISH(Original Instructions)
POSSIBLE CAUSE
On/O ff switch is in the"OFF" (O) posi-
tion.
Power cord is not plugged in.
Defective extension cable.
E l e c t r i c a l o u t l e t d o e s n o t s u p p l y
adequate power.
Tripped pressure washer circuit breaker
Diameter of garden hose is too small.
Water supply is restricted.
Not enough water supply
Power nozzle is in low- pressure posi-
tion.
Not enough inlet water supply.
Pump is sucking air.
Discharge nozzle is obstructed.
FI HU CS RU RO PL
SOLUTION
Turn switch to the "ON" ( | ) position.
Squeeze gun trigger.
Plug in power cord.
Try without extension cable.
Try a different outlet.
Allow to cool, and restart unit.
Replace with a 1" (25 mm) or 5/8" (16 mm)
garden hose.
Check garden hose for kinks, leaks and
blockage.
Open water source fully.
Turn power nozzle to high- pressure posi-
tion.
Turn water on fully.Check garden hose for
kinks, leaks or blockage
Check that hoses and fittings are airtight.
Turn "OFF" machine, and purge pump by
water emerges hrough the nozzle.
Blow out or remove debris with a fine
needle.
Run distilled vinegar through detergent
tank.
22
SL HR ET LT LV SK BG