Zipper Maschinen ZI-HAEK4000 Manual De Instrucciones página 23

Before the start, after the failure or shock, be sure to check:
the device and make sure that it is in good condition

if the hopper is empty

if the blades are secure and undamaged

the muffle

Change damaged parts immediately
TRANSPORT NOTES:
Switch off the engine and let cool down

Never lift or carry the machine while the engine is running

Wait till the blade are completely stopped

Secure the machine

Empty tank completely, avoid fuel spillage

To avoid damage to the device never drag but always lift correctly.

STORAGE NOTES:
Clean and dry the machine

Empty tank completely, avoid fuel spillage

Let cool down the engine

Store in a dry, out of reach of children place, well packaged

Do not store machines with fuels and fuels close to combustible and highly inflammable materials

as well as sparks and open flames.
Never remove the fuel tank cap when the engine is running or hot

Switch of the engine and disconnect the spark plug lead:
Before check, clean or work on the machine

Before eliminating faults

Before the start, after the failure or shock, be sure to check the device and make sure that it is in

good condition
If the shredder starts to vibrate abnormally, stop the engine immediately and locate the cause.

Vibrations generally terminate in malfunction.
If the machine becomes clogged

Before refuelling

Always if you leave the machine

11.3 Remaining risk factors
It is important to ensure that each machine has remaining risks.
In the execution of all work (even the simplest) greatest attention is
required. A safe working depends on you!
Even if the machine is used as required it is still impossible to eliminate certain residual risk factors
totally. The following hazards may arise in connection with the machine´s construction and design:
• Risk of injury to the hands / fingers due to careless feeding of chopping material.
Feed the chopping material slowly and carefully into the in-feed. Automatic feeding!
• Risk of injury: hair and loose clothing, etc. can be captured and wound up! Safety regulations
must be observed with regard to clothing.
 Risk of injury by tilting the machine
• Risk of injury to the eye by flying debris, even with safety goggles.
• Risk of injury to the hearing by prolonged labor without hearing protection.
• Risk of burns: Touching the mufflers, exhaust and other machine components which can be hot
after prolonged continuous operation or when the engine is hot cause severe burns.
These risk factors can be minimized through obeying all security and operation instructions, proper
machine maintenance, proficient and appropriate operation by persons with technical knowledge and
experience.
In spite of all safety is and remains her healthy common sense and their corresponding technical
qualification / training for use of the machines most important safety factor!
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-HAEK4000
WARNING
23