Publicidad
Idiomas disponibles
Idiomas disponibles
Slowly pull the start handle until the resistance is reached, then stop pulling. At that point, the
valves are closed, that will prevent dust and rust from entering the cylinder.
•
Store in a dry, out of reach of children place, well packaged.
14.1.11
Disposal
Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. Avoid damage caused by leaking
operating supplies: drain the operating supplies prior to disposal! When you buy at your
local dealer for a replacement unit, the latter is obliged to exchange your old.
15
TROUBLE SHOOTING
Shut off the machine, let it cool down, disconnect spark plug cap from spark plug
Trouble
Engine does not start
To low power
No automatically
feeding of the
shredded material
Machine vibrates or
makes unusual noises
Engine overheats
Chips do not come out
of the discharge
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-HAEK4000
ATTENTION
Possible cause
Ignition switch defect
Engine switch OFF
No fuel, or fuel is old and
stale
Engine oil is low
Spark plug dirty or damaged
Fuel line faulty
Air filter dirty
V-belt
Overload
Blockage
Blades blunt
Blades blunt
Screws, nuts or other parts
are loose
Impeller or blades have
woody residue or chucks
stuck to them
Chips and sawdust around
the engine
Air filter dirty
Discharge chute or hopper is
clogged.
Repair or change
Set the engine switch to ON
Refuel
Add oil
Clean or change
Check fuel line for damage and
kinks
Clean or change
Tighten or change
Reduce material feeding
Remove shredded material
Replace/ sharpen blades
Replace/ sharpen blades
Fix parts
Clean the impeller and blades
Clean the engine surface
Clean or change
Turn of the engine, disconnect the
spark plug, then clean out the
machine
NOTICE
Solution
30
Publicidad
